Castable | Slaxel
Cart (0)
The cart is empty.
Continue Shopping


Castable is a additive printing resin for bridges, crowns and frameworks.

€ 208,00 - € 925,00
Add to Cart

A suitable balance of strength and flexibility, allows to check the couplings directly on the model after printing, without any risk of distorsion.
Excellent adhesion on built plate, it allows an easy detachment and quick cleaning cycle with ethanol or isopropilic alchool. Safe, with no unpleasant odors, it requires an UV post treatment process at 405 nm.

Technical specification
Relative density ca 1.1 - 1.2    
Viscosity mPas 450 - 850    
Layer thickness 0.05 mm LCD LCD Mono DLP
Base exp layer 6 - 8 60 50 45
Normal exp. layer 6 4 3
Reference temperature 25 C°    
UV 405 nm uniform light source min. 45 Watt    

Above 25 C° reduce the layers by 0.5 sec. every 3 degrees in up, while increase them by 1 sec. for every 2 degrees to down.

Best practices

All 3D printing resins are heat sensitive, therefore the best prints are achieved in heated environments and in hot seasons.
During the cold months put the printer in a warm place and preheat the resin up to 28 C° for at least 20 min. If necessary, also preheat the building plate and shake well the bottle before the use, if possible with a roller agitator. Remove and filter the resin from the vat at the end of each print. Store the resins between 10 and 21 C° and protected from direct light.

It might also interest you
Information request
Last Name*
I have read the information Privacy and Cookie policy and I give my consent*
(*) Required fields
Send the message