Flexible | Slaxel
Cart (0)
The cart is empty.
Continue Shopping


Flexible is a functional photopolymer for additive manufacturing that meets excellent flexural and tensile physical properties with a relative high degree of elongation.

€ 132,00 - € 595,00
Add to Cart

Well suited for motorsport and marine application, it shows lightfastness and weatherability for end-use plastic parts. Excellent adhesion on smooth surfaces, it allows an easy detachment and quick cleaning cycle with ethanol or isopropilic alchool. Safe, bisphenol free, with no unpleasant odors, it requires an UV post treatment process at 405 nm for ensure full performance. An heat treatment at 80 C °for 20 min, increases the surface hardness and the stiffness.
Other colors are available on request with minimum order.

Technical specification
Relative density ca 1.1 - 1.2    
Viscosity mPas 550 - 1350    
Layer thickness 0.05 mm LCD LCD Mono DLP
Base exp layer 6 - 8 60 50 45
Normal exp. layer 6 4 3
Reference temperature 25 C°    
UV 405 nm uniform light source min. 45 Watt    

Above 25 C° reduce the layers by 0.5 sec. every 3 degrees in up, while increase them by 1 sec. for every 2 degrees to down.

Best practices

All 3D printing resins are heat sensitive, therefore the best prints are achieved in heated environments and in hot seasons.
During the cold months put the printer in a warm place and preheat the resin up to 28 C° for at least 20 min. If necessary, also preheat the building plate and shake well the bottle before the use, if possible with a roller agitator. Remove and filter the resin from the vat at the end of each print. Store the resins between 10 and 21 C° and protected from direct light.

It might also interest you
Information request
Last Name*
I have read the information Privacy and Cookie policy and I give my consent*
(*) Required fields
Send the message