Orthoflex | Slaxel
Cart (0)
The cart is empty.
Continue Shopping


Orthoflex is a 3D printing resin, formulated to print temporary positioners of brackets and other functional orthodontic devices.

€ 162,00 - € 725,00
Add to Cart

The excellent flexibility and tear resistance allows many positioning for quick and precise control of the etching and bonding phase.
Excellent adhesion on built plate, it allows an easy detachment and quick cleaning cycle with isopropilic alchool. Safe, bisphenol-free, with no unpleasant
odors, an UV post curing process is required. Compatible with disinfectants and autoclave. Under medical certification process, it is only suitable for test.

Technical specification
Relative density ca 1.1 - 1.2    
Viscosity mPas 450 - 950    
Layer thickness 0.05 mm LCD LCD Mono DLP
Base exp layer 6 - 8 50 45 40
Normal exp. layer 5 3,5 2,5
Reference temperature 25 C°    
UV 405 nm uniform light source min. 45 Watt    

Above 25 C° reduce the layers by 0.5 sec. every 3 degrees in up, while increase them by 1 sec. for every 2 degrees to down.

Best practices

All 3D printing resins are heat sensitive, therefore the best prints are achieved in heated environments and in hot seasons.
During the cold months put the printer in a warm place and preheat the resin up to 28 C° for at least 20 min. If necessary, also preheat the building plate and shake well the bottle before the use, if possible with a roller agitator. Remove and filter the resin from the vat at the end of each print. Store the resins between 10 and 21 C° and protected from direct light.

It might also interest you
Information request
Last Name*
I have read the information Privacy and Cookie policy and I give my consent*
(*) Required fields
Send the message