Temporary

The good balance of properties such as stiffness, elongation and hardness, allows it to print multi elements structure with strong stability and translucency. Compatible with disinfectants and autoclave, safe, bisphenol-free, with no unpleasant odors, it requires a post UV treatment at 405 nm.
Use isopropyl alcohol for cleaning prints and tray. Under medical certification process, it is only suitable for test and restorations as synthetic ivory.

Above 25 C° reduce the layers by 0.5 sec. every 3 degrees in up, while increase them by 1 sec. for every 2 degrees to down.

All 3D printing resins are heat sensitive, therefore the best prints are achieved in heated environments and in hot seasons.
During the cold months put the printer in a warm place and preheat the resin up to 28 C° for at least 20 min. If necessary, also preheat the building plate and shake well the bottle before the use, if possible with a roller agitator. Remove and filter the resin from the vat at the end of each print. Store the resins between 10 and 21 C° and protected from direct light.